How to use AxTraxPro on a machine with more than 1 Network adapters.

AxTraxPro server service use .NET network structure, AxTraxPro cannot determent which network adapter to use and a network adapter will automatically be assigned to the highest priority adapter on the machine in case of more than 1 network adapters available on the machine.

To avoid the automatic assignment of network adapter to AxTraxPro server we need to set the priority (Interface metric) of each adapter on the machine. doing such should not have any effect on the daily operation of the machine.

please follow those steps to set Networks adapters priorities:

From PC control Panel, Network and Internet, Network and Sharing Center select Change adapter setting:
From the available adapter list right click the adapter to set in high priority (the adapter AxTraxPro should use) and select Properties:
From the Items List select Internet Protocol Version 4 (TCP/IPv4) and click Properties:
Under General tab Click Advanced:
Under IP Setting tab remove the Check Mark form the Automatic metric and set the Interface metric to “1”:
Repeat the same process for each adapter on the Machine and increase the Interface metric by 5 for each Adapter, the 2nd set to “6” the 3rd Set to “11” and so on.
Go to services and restart "AxTraxPro " server service

Related Articles
How to use AxTraxNG on a machine with more than 1 Network adapters.
AxTraxNG server service use .NET network structure, AxTraxNG cannot determent which network adapter to use and a network adapter will automatically be assigned to the highest priority adapter on the machine in case of more than 1 network adapters ...
Secure Communication on AxTraxPro Web
This article will take you with the steps requires to allow secure communication using SSL to AxTraxPro web-client, this article utilize the OpenSSL Project cryptography, you you already have a valid certification for SSL you can move to step. "To ...
What are the minimum requirements for AxTraxPro Server, Web Server, and Client installation
The minimum spec for AxTraxNG Server and Client as listed in the manual are: CPU: 2.4GHZ (i5) or higher OS: win 10 or higher, up to win server 2019 is supported. RAM: 8GB (min 12GB is recommended) Network: network adapter 100MB Hard Drive: 500 GB ...
How to configure AxTraxPro Web Client for remote access
The Rosslare AxTraxPro™ Web Client software is a web-based software management system intended for the ongoing management of the AxTraxPro™ Server. Operators can access the system from a web browsers for daily tasks. The AxTraxPro access control ...
How to upgrade from AxTraxNG to AxTraxPro
This technical note gives the procedure to upgrade from AxTraxNG™ v27.7.1.18 or above to AxTraxPro™ v28.0.x.x. Upgrade to AxTraxPro is only available from AxTraxNG version 27.7.1.18 and above, if your version of AxTraxNG lower then AxTraxNG version ...