Rosslare UHF Tag (UVG-26A-3000 / UVT-26A-3000 )
Rosslare UHF Tag is designed to be mounted in a horizontal direction on the inside of the vehicle's windshield/windscreen. This tag is tuned to the dielectric properties of the windshield glass so proper performance is achieved only when stuck to the windshield glass. The Rosslare UHF Tag must be mounted at least two inches from the metal support posts on either side. The preferred placement is at the top /left (passenger side) of the windshield. This mounting position is always recommended when the Reader is positioned on the left side of the travel lane.
Some Vehicle will have a dedicate location for UHF tags
Precautions
1) the mounting area must be clean and free of oils or cleaning solutions. Do Not Attempt to remove this sticker once it is applied, you are very likely to compromise the antenna which will render the tag useless.
2) Do not bend the tag when removing the backing or applying to the windshield, as this can damage the chip or antenna and make the tag stop working. The tag cannot be repaired and must be replaced.
Tag care
Proper care of tag must be taken before installation, otherwise chance of damage and reduced performance. Following precautions will help in reducing chances of damage.
1) strictly avoid bending or folding of the tags
2) Don’t staple/ clip tags to paper
3) Don’t write on tags with a ballpoint pin
4) Don’t allow the tags to get wet
If the tags are subjected to any of the above actions prior to installation, they may be damaged and require replacement